Durable & Strong Constructed of pure brass and is heavy 1/2 not rusted Long lasting Due to its brass construction, it does not break if it hits the ground. Tested over a large number of turns. Includes two parts Spray fits firmly inside the 1/2" holder, which is connected to the pipe via the holder.

You can use the pipe without the spray by simply removing the spray and leaving the holder on the pipe. No need to remove the holder, then. A clever design. No need to remove the holder, then. A clever design.Adaptive fit Attaching it to 1/2" pipe takes hardly any time. works with half-inch hose pipes of any thickness.

The No Squeeze, easy flow control allows for effortless use. Easily twist the nozzle head to turn it on and off or to control the water flow and patterns. Water gun for car washing doesn’t require you to hold down a handle for water to flow or fumble with flimsy stops to set a flow rate. With this spray water gun , simply turn the nozzle head to your desired water flow and it stays constant without anymore effort on your part.

Water spray nozzle is a flow controller so it creates extra pressure by flow control. It can boost pressure to some level only. If incoming water pressure from the hose pipe is low then it cannot boost the pressure very high. For insufficient water pressure from the tap (hose pipe), if you need very high pressure then you require extra water pump.

There is no need to be concerned about the hose nozzle degrading into plastic trash after a season of spraying. Spray comes with internal seals for a precise fit with 1/2" holders. Inner seals on the holder allow it to perfectly fit the pipe. Simple to assemble and disassemble. 9.5 cm Nozzle Length 3.5 cm is the connector length.